Cisco 4507 Supervisor Slot

admin
Jun 4, 2012

I was upgrading IOS on 4507 R with dual supervisor.I download the IOS on Active supervisior and did reboot.After reboot i login to switch then i got switch standby prompt.I found that after reboot active supervisior became standby supervisior.
Now new IOS is on standby supervisior.Need to confirm below..So this means that IOS does not syn within the supervisiors as compared to config right ?
-Which command i can use that will copy IOS from standby supe to Active supe??
-Which command i can use that will show both active and standby supe with new IOS?
-Is there any command that i can use to switchover from active to standby supe??

Jun 4, 2012

Cisco 4507 Datasheet

4507

Dual Supervisor Engine on 4507 Switch Hello, I have a Catalyst 4507 Switch with dual supervisor engine module. (slot: 2) information is not available because it. The Catalyst 4507R-E switch is a 7-slot horizontal chassis supporting redundant power supplies, redundant supervisor engines, and slots for up to six modules. Cisco Catalyst 4500 Series offers non-blocking Layer2/3/4 switching with integrated resiliency, further enhancing control of converged networks. . Supervisor Engine 2 must be installed in slot 1 or slot 2. Supervisor Engine 32, Supervisor Engine 32 PISA, Supervisor Engine 720, and Supervisor Engine 720-10GE must be installed in slot 5 or slot 6. Note Slots not occupied by supervisor engines can be used for modules. Check your software release notes for any restrictions on the type. When Supervisor V is used in the 4510R chassis, Slot 10 (Flex-slot) will support a sub-set of linecards: 2-port GBIC (WS-X4302-GB) and Access Gateway Module (WS-X4604-GWY). This is due to the switching capacity of the Supervisor Engine V, and not a limitation of the 4510R chassis.

Cisco 4507 Supervisor Slot Tool

I was upgrading IOS on 4507 R with dual supervisor.I download the IOS on Active supervisior and did reboot.After reboot i login to switch then i got switch standby prompt.I found that after reboot active supervisior became standby supervisior.
Now new IOS is on standby supervisior.Need to confirm below..So this means that IOS does not syn within the supervisiors as compared to config right ?
-Which command i can use that will copy IOS from standby supe to Active supe??
-Which command i can use that will show both active and standby supe with new IOS?
-Is there any command that i can use to switchover from active to standby supe??